MacDon M200 Návod k obsluze stáhnout pdf (Strana 132)

MAINTENANCE AND SERVICING

Form 169017 / 169087 / 169095 130 Revision C

7.7.5 PARK BRAKE

The brake is applied when the interlock is fully

engaged. To engage the interlock and hence the

brake, the GSL must be in the N-DETENT

position, and the steering wheel centered.

7.7.5.1 Interlock Switch

DANGER

Stop engine and remove key from ignition

before leaving Operator’s seat for any reason.

A child or even a pet could engage an idling

machine.

The GSL switch is located inside the console, but

can easily be removed for adjustment or

replacement. Check that GSL contacts switch

lever and pushes plunger.

Adjust or replace switch as follows:

a. Place GSL in N-DETENT, shutdown engine, and

remove key.

b. Remove the five screws (A) securing control panel

(B) to console, remove panel and store in the tray.

c. From inside the console, pull switch support (C) so

that rubber nuts (D) pull out of mounting holes,

and remove switch support from console.

d. Adjust switch (E) as follows:

1. Loosen screws (F), and rotate switch on

support sufficiently so that GSL will contact

switch lever (G) and push in the plunger.

2. Tighten screws (F).

e. Replace switch as follows:

1. Disconnect wiring harness at connector (G).

2. Cut nylon ties (H).

3. Remove screws (F), and remove switch.

4. Install new switch on support with screws.

5. Secure harness to support (C) with nylon ties

(H).

6. Connect harness to console wiring (G).

(continued next page)

1 2 ... 127 128 129 130 131 132 133 134 135 136 137 ... 233 234

Žádné komentáře

MacDon M200 Návod k obsluze Strana 132